These instructions are also available in movie format:

• NetVista 6043, 6790, 6791, 8181, 8303, 8304, 8312 - AGP adapter removal movie
• NetVista 6043, 6790, 6791, 8181, 8303, 8304, 8312 - AGP adapter installation movie

Note: This computer has three expansion slots for PCI adapters and one slot used for an AGP adapter. Adapters must be low profile. This computer supports adpaters up to 168 mm (6.6 inches) long.

Adapter installation:

Note: Remove the cover. For more information click Cover removal.

1. Pivot one of the drive bay latch handles toward the front of the computer and then pivot the drive bay cage upward, as shown, until it is latched in the up position. Repeat this procedure for the remaining drive bay.
   
   
   
   
2. Remove the support bar by pulling it outward from the computer.
   
   
   
   
3. Remove the adapter slot cover latch and the slot cover for the appropriate expansion slot.
   
   
   
   
4. Remove the adapter from its static-protective package.
   
5. Install the adapter into the appropriate slot on the system board.
6. Install the adapter slot cover latch.
   
   
   
   
7. Replace the support bar and reattach the two drive bays.