The most likely cause is listed first. A numeric error is displayed for each error detected in POST or system operation. In the displays, n can be any number.
| 0175 |
Bad CRC1, stop POST task. The EEPROM checksum is not correct. |
System board.
|
| 0187 |
EAIA data access error. The access to EEPROM has failed. |
System board.
|
| 0188 |
Invalid RFID serialization information area or bad CRC2. The EEPROM checksum is not correct. |
System board.
|
| 0189 |
Invalid RFID configuration information area. The EEPROM checksum is not correct. |
System board
|
| 0190 |
Critical low battery error. |
- Charge the battery pack
- Battery pack
|
| 0193 |
RF antenna has been removed. |
Enter the supervisor password
|
| 0194 |
The computer has been carried through a security gate. |
Enter the supervisor password
|
| 0195 |
Security hardware tamper detected |
- Enter BIOS Setup Utility by entering the supervisor password, and select Config, select Security Chip, then click Clear Security Chip to clear this error
- Security Chip
- System board
|
| 0196 |
Security hardware removed |
- Enter BIOS Setup Utility by entering the supervisor password, and select Config, select Security Chip, then click Clear Security Chip to clear this error
- Security Chip
- System board
|
| 0197 |
Invalid Remote change requested. |
The remote configuration for the security chip has failed. Confirm the operation and try again. |
| 01C9 |
More than one Ethernet devices are found. Remove one of them and press the Esc key to continue. |
- Remove either a Mini PCI Ethernet card or an Ethernet daughter card, other wise press the Esc key to ignore the warning message.
- System board
|
| 0200 |
Hard disk drive error. The hard disk drive is not working. |
- Reseat the hard disk drive.
- Load Setup Defaults in BIOS Setup Utility.
- Hard disk drive.
- System board
|
| 021x |
Stuck key Keyboard error |
Run an interactive tests of the keyboard and the auxiliary input device.
|
| 0220 |
Monitor type error. Monitor type does not match the one specified in CMOS. |
Load Setup Defaults in BIOS Setup Utility.
|
| 0230 |
Shadow RAM error. The shadow RAM failure at offset nnnn. |
System board.
|
| 0231 |
System RAM error. System RAM failure at offset nnnn. |
- DIMM.
- System board.
|
| 0232 |
Extended RAM error. Extended RAM failure at offset nnnn. |
- DIMM.
- System board.
|
| 0250 |
System battery error. System battery is dead |
Replace the backup battery and run BIOS Setup Utility to reset the time and date.
|
| 0251 |
System CMOS checksum bad. Default configuration used |
Replace the backup battery and run BIOS Setup Utility to reset the time and date.
|
| 0252 |
Password checksum bad. The password is cleared. |
Reset the password by running BIOS Setup Utility.
|
| 0260 |
System timer error |
- Replace the backup battery and run BIOS Setup Utility to reset the time and date.
- System board.
|
| 0270 |
Real time clock error |
- Replace the backup battery and run BIOS Setup Utility to reset the time and date.
- System board.
|
| 0271 |
Date and time error. Neither the date nor the time is set in the computer. |
Run BIOS Setup Utility to reset the time and date.
|
| 0280 |
Boot incomplete error. Default configuration used |
- Load Setup Defaults in BIOS Setup Utility.
- DIMM.
- System board.
|
| 02B2 |
Incorrect drive A type. |
- Diskette drive.
- External FDD cable.
- I/O card
|
| 02F4 |
EISA CMOS not writable. |
- Load Setup Defaults in BIOS Setup Utility.
- Replace the backup battery.
- System board.
|
| 02F5 |
DIMM test failure |
- DIMM.
- System board.
|
| 02F6 |
Software NMI failure |
- DIMM.
- System board.
|
| 02F7 |
Fail-safe timer NMI failure |
- DIMM.
- System board.
|
