Realtek LAN Driver for Windows XP - 3000 C200, N100

Summary of changes

Installation instructions

Determining which version is installed

Version 5.641.0209.2006

• (Fix) The computer hangs after connected to the LAN with PPPoE protocol.

Version 5.635.0923.2005

• (New) Initial release for the 3000 N100
  
  

1. Start Microsft Windows XP and logon with administrative privileges.
2. Extract this package by double-clicking the downloaded file.
   The default extract location is C:\IBMTOOLS\DRIVERS\ETHRTK
3. Click Start, then click run.
4. Specify SETUP.EXE with the full path name (ex: C:\IBMTOOLS\DRIVERS\ETHRTK) where you extracted the package in step 2 above, and click OK.
5. The device driver wizard will be launched.
6. Click Next.
7. Click Finish.

Unattended install
This procedure is intended for system administrator use only.

1. Start Microsft Windows XP and logon with administrative privileges.
2. Extract this package by double-clicking the downloaded file.
   The default extract location is C:\IBMTOOLS\DRIVERS\ETHRTK
3. From a command prompt, navigate to the driver location.
4. Type "SETUP.EXE -S" and press Enter.

Uninstall

1. Start Microsft Windows XP and logon with administrative privileges.
2. Click Start, then click Control Panel.
3. In the Control Panel window, click Add or Remove Programs.
4. Select REALTEK Gigabit and Fast Ethernet NIC Driver.
5. Click Change/Remove.
6. Click OK.
7. Click Finish.
   
   

1. Right-click My Computer and click Properties.
2. Click the Hardware tab and click Device Manager.
3. Click the + sign in front of the Network adapters category.
4. Double-click Realtek RTL8139 Family PCI Fast Ethernet NIC.
5. Click the Driver tab. The driver version will be displayed.