Card reader (Ricoh 5in1) for Windows Vista 32-bit - 3000 N200 (0769)

	Summary of changes
	Installation instructions

• (New) Support for 3000 N200 - Initial release
  
  
  

1. Start Windows and logon with administrative privileges.
2. Double-click this package to extract it onto the hard drive. The default location is C:\DRIVERS\Vista32\5IN1
3. Click Start, select All Programs, select Accessories, then click Run...
4. Specify SETUP.exe with the full path name where you extracted the package in the step 2, and click OK.
   For example, C:\DRIVERS\Vista32\5IN1\SETUP.exe
   For Unattended Install, type C:\DRIVERS\Vista32\5IN1\SETUP.exe -s
5. Follow the instructions on screen.
   • If the message, "An unidentified program wants access to your computer" appears,click Allow to continue installing.
   • If the message "Windows can't verify the publisher of this driver software" appears, click Install this driver software anyway to continue installing.
   • If the message "This program might not have installed correctly" appears , click This program installed correctly to finish installing.
6. If needed, restart the system.

Update install
A driver is already assigned in Device Manager

1. Start Windows and logon with administrative privileges.
2. Click Start, and then click Control Panel.
3. Click System and Maintenance, select System, and then click Device Manager.
   • If the message "Windows needs your permission to continue" appears, click Continue.
4. Expand the "IDE ATA/ATAPI Controllers" section, right-click:
   • Ricoh Memory Stick Controller
   • Ricoh SD/MMC Host Controller
   • Ricoh xD-Picture Card Controller
5. Click Update Driver Software... and choose Browse my computer for driver software.
6. Click Browse.. and choose location. The default location is C:\DRIVERS\Vista32\5IN1
7. Click Next.
8. If needed, restart the system.